SET UP YOUR NETGEAR ROUTER

Contacte al anunciante
Contacte al anunciante

Log in to your Netgear router. This can usually be done by going to http://www.routerlogin.com/ and entering the username and password for your Netgear router. To setup Netgear router as access point, username and password can often be found on a sticker under your router. Unless you have changed it manually, the username and password is normally admin and password by default. Navigate to ADVANCED ➝ Advanced Setup ➝ Wireless Settings. Check the box Enable AP Mode. Verify that Get IP Address Dynamically and Get DNS Server Address Dynamically are both checked. Click Apply. Connect a network cable between LAN port on your Vilfo and the WAN port on your Netgear router.

Contact us:

Email: [email protected]

Web: https://connectrouter.com

Log in to your Netgear router. This can usually be done by going to http://www.routerlogin.com/ and entering the username and password for your Netgear router. To setup Netgear router as access point, username and password can often be found on a sticker under your router. Unless you have changed it manually, the username and password is normally admin and password by default. Navigate to ADVANCED ➝ Advanced Setup ➝ Wireless Settings. Check the box Enable AP Mode. Verify that Get IP Address Dynamically and Get DNS Server Address Dynamically are both checked. Click Apply. Connect a network cable between LAN port on your Vilfo and the WAN port on your Netgear router.

Contact us:

Email: [email protected]

Web: https://connectrouter.com

Contacte al anunciante